Push the mold to the right to align the upper and lower molds, place the base of the pin on the top of the mold with the sharp face up 3. In the pressure to do the mold, pay attention to the three pins on the mold is not through the patch of holes, the left hand to hold the fuselage, the right hand pressed the handle, the spring can be suppressed 4. The mold pushed to the left in the end, the upper and lower mold against the pressure, the card top entry the upper mold, the mold and the right mold press down together, the the four iron pin on the mold must pass through the round hole 5. 1 Pcs Badge Machine with screws accessories not include mold and badge.
Please allow 1-3cm error due to manual measurement and make sure you do not mind before ordering. Please understand that colors may exist chromatic aberration as the different placement of pictures. International buyers please note: a. The item "25mm Button Maker Badge Press Machine Circle Cutter Pinback Buttons A" is in sale since Saturday, July 31, 2021. This item is in the category "Crafts\Multi-Purpose Craft Supplies\Crafting Tools\Badge & Button Makers".
The seller is "aalike" and is located in Shenzhen. This item can be shipped worldwide.